Motomaster Battery Charger: 111568 Manual

Clean the terminal posts thoroughly using a wire brush to remove corrosive buildup. If you are working on a conventional flooded lead-acid battery with removable caps, verify that the fluid covers the internal plates, adding distilled water if necessary. 2. Making the Connections (Negative-Ground Vehicles)

Because this is a manual charger, leaving it connected indefinitely will boil the battery electrolyte, damage the internal lead plates, and permanently ruin the battery. Never leave it unattended overnight.

This paper is a synthesized reference based on standard manual charger designs. Always verify specific details against the original printed MotoMaster 111568 manual provided with your unit.

Battery charging produces explosive hydrogen gas. Protect yourself by adhering to standard safety protocols:

When a battery is deeply discharged, the needle will point to a higher number (close to 10 on the 10A setting). motomaster battery charger 111568 manual

Best for small batteries (motorcycles, lawnmowers) or for maintaining a fully charged large battery.

A.

The MotoMaster 11-1568 battery charger Go to product viewer dialog for this item.

Plug the charger's power cord into a grounded 120V AC electrical outlet. Clean the terminal posts thoroughly using a wire

Attach the Red clamp to the positive terminal of the battery.

Disconnect immediately. This unit is strictly rated for 12V battery configurations. Maintenance and Storage

Clean the clamps after every use using a paste of baking soda and water to neutralize any battery acid residue.

The MotoMaster 011-1568-4 (often searched as 111568) is a versatile, fully automatic battery charger designed for standard automotive, marine, and deep-cycle 12V batteries. Known for its reliability and simple plug-and-play operation, this charger ensures your vehicles stay powered through winter storage or sudden battery drains. Always verify specific details against the original printed

Once the needle stabilizes at a very low level (usually under 1 to 2 amps) and stays there for an hour, the battery is fully charged. Unplug the charger immediately. 5. Disconnecting the Charger Unplug the AC power cord from the wall outlet. Remove the Negative (Black / -) clamp first. Remove the Positive (Red / +) clamp last. Using the 50A Engine Start Feature

For regular flooded lead-acid maintenance-free car batteries.

Wipe the copper clamps down with a baking soda and water paste after use to neutralize any residual battery acid.