Ts1162 Installation Manual Best -

Verify the D+ and D- wires are not swapped. Ensure the address DIP switches are set correctly.

Before beginning installation, ensure the following items are available. Using the correct tools prevents damage to the vehicle paint and the rails themselves.

Refer to the troubleshooting section of the manual to identify the specific code.

:

Route the power and data cables through the rear cable entry port of the mounting bracket.

For the specific RS-485 wiring color codes and pinouts, refer to the system wiring diagram in the Challenger panel's main installation manual. Ensure the incoming power supply is within the specified 10.8 to 30 VDC range.

manuals are often restricted to authorized installers, the procedure follows standard Tecom RAS installation protocols as seen in similar models like the TS1001 : ts1162 installation manual

: Join data cable shields where the cable extends past the device. Connect the shield to the LAN earth terminal at the panel end. aritech.com.au 5. Final Assembly Reattach Body

Install indoors in a well-ventilated area away from direct sunlight, extreme dust, and moisture. Safety Guidelines

As the exact installation steps vary slightly depending on the specific vehicle model year, the following is a comprehensive report detailing the installation process, tools required, and safety warnings associated with the TS1162 side rails. Verify the D+ and D- wires are not swapped

: Secure the base to a flat, solid surface using the provided mounting holes.

+---------------------------------------------+ | [ 1 ] [ 2 ] [ 3 ] [ 4 ] [ 5 ] [ 6 ] | | V+ V- GND Signal+ Signal- Shield | +---------------------------------------------+ Power Supply Connections

Run the power line into Terminal 5, and run the wire out of Terminal 6 directly to the load (heater/cooler). Using the correct tools prevents damage to the