The error code on a Ricoh device indicates a Fusing Pressure Release Motor Error . This is a hardware-level malfunction where the machine is unable to detect the correct position of the pressure rollers within the fusing unit. 🔍 Core Cause
Do you hear any from the right side of the machine before the error displays? Share public link
The of your Ricoh machine (e.g., MP 7502, MP 7503).
In a world where printers are a dime a dozen, it's refreshing to come across a model that truly stands out from the crowd. The Ricoh SC569-00, affectionately known as a workhorse in the printing industry, has been making waves with its impressive performance and reliability. sc569-00 ricoh
The SC569-00 is a hardware issue requiring the inspection of the fuser area's moving parts and sensor connections.
Paper jams or debris within the fuser unit are preventing movement. Step-by-Step Troubleshooting for SC569-00
If you are unsure or uncomfortable performing these checks yourself, it is highly recommended to contact a qualified Ricoh service technician to avoid causing further damage. We hope this article has helped you better understand the SC569-00 error on your Ricoh device. The error code on a Ricoh device indicates
| Priority | Cause | Explanation | |----------|-------|-------------| | 1 | | Tiny paper pieces or a loose staple lodged near the alignment fence guide rails. | | 2 | Alignment fence mechanical binding | Fence skewed, rail dirty/warped, or spring detached. | | 3 | Home position sensor failure | Sensor dirty, disconnected, or failed (e.g., photo-interrupter stuck ON/OFF). | | 4 | Alignment fence motor failure | Motor not turning (open winding, broken gear, harness fault). | | 5 | Motor drive circuit / harness | Broken wire between finisher controller board and motor/sensor. | | 6 | Finisher main board failure | Rare; typically last resort. |
Every time a Ricoh copier starts up, leaves energy-saving mode, or finishes a print job, the machine runs a self-test. During this phase, a specialized contact motor rotates a camshaft. This pushes the pressure levers forward to compress the fuser rollers together, creating a tight gap known as the "nip."
Ricoh fusers rely on a U-shaped photointerruptor sensor to track the gear position. Because this sensor operates next to high-heat components, it is highly prone to heat degradation, dust accumulation, or outright failure. Share public link The of your Ricoh machine (e
If a physical inspection and power cycle don't clear the error, you may need to perform a reset from the printer's service mode. If you are a qualified technician, you can follow these steps:
(typically 20lb/75gsm) while troubleshooting to rule out media-related stress on the motor. Service Mode Reset
Check for wrapped paper or "scrunched" sheets inside the fuser that might be blocking the pressure mechanism.