The is more than just a button map—it is the key to unifying your home theater. By understanding how to program device codes, create macros, and perform resets, you transform a simple remote into a powerful control center.
To program the remote using a specific manufacturer code, follow these steps:
Proper battery maintenance ensures your programmed codes do not erase prematurely.
: Remove the batteries and hold the Power button for 20 seconds to clear residual power before reinserting fresh AAA batteries .
When the device turns off, press the button immediately to save the code. The light will flash twice to confirm. 4. Resetting the Remote to Factory Default onkyo rc-799m remote manual
The is a dedicated audio-video receiver remote primarily used for controlling Onkyo and Integra receivers like the TX-SR309 or HT-R391. It typically requires no programming to work with its original receiver right out of the box. Quick Setup & Programming
To program your Onkyo RC-799M Go to product viewer dialog for this item.
.
The you want to program. The specific issue or error you are experiencing. The is more than just a button map—it
The RC-799M is officially compatible with the following Onkyo AV Receiver models: Amazon.com.au HT-R Series : HT-R391, HT-R548, HT-R558, HT-R590, HT-R591 HT-RC Series : HT-RC330, HT-RC430 HT-S Series : HT-S3500, HT-S5400, HT-S5500 TX-SR Series : TX-SR309, TX-SR313 Key Resources Full Guide : A detailed Button Mapping and Functionality Guide for various modes (Receiver, TV, DVD, etc.). Official Downloads
Visit Onkyo’s support site and search for "TX-NR807 manual." The remote section is identical.
: Press CH + or CH - repeatedly to cycle through codes.
: Onkyo receivers and remotes can use different Remote IDs (ID1, ID2, ID3) to avoid interfering with other equipment. If your receiver display says "Remote ID Error," press and hold Setup and Return simultaneously for 3 seconds, then press number 1 , 2 , or 3 to match the ID displayed on your receiver panel. : Remove the batteries and hold the Power
If the code is accepted, the indicator light will flash twice. If it flashes rapidly or turns off without flashing, repeat the process with a different code.
Replace both AA batteries. Ensure they are inserted correctly matching the (+) and (-) polarities inside the battery compartment. Weak batteries may have enough power to light up a button but not enough power to transmit an IR signal. 3. Only certain buttons work for programmed devices
button (e.g., TV, BD/DVD, CBL/SAT) while simultaneously holding down the button for approximately 3 seconds. Wait for Indicator