Xh-m608 Manual Hot! ✔
This comprehensive manual covers the technical specifications, wiring configurations, and step-by-step programming instructions for the XH-M608 module. Technical Specifications Specification DC 6V to 60V Voltage Display Accuracy Control Accuracy Output Type Direct Output (matches input voltage) Voltage Error Tolerance Maximum Relay Current 30A (Recommended safe limit: 20A continuous) Dimensions 81mm x 54mm x 18mm Compatible Battery Types Lead-acid, AGM, Gel, Lithium-Ion, LiFePO4 Board Layout and Interface
This comprehensive manual covers the technical specifications, wiring configurations, and step-by-step programming guides for the XH-M608 module. Technical Specifications
Measuring approximately and weighing just 33-80 grams , the XH-M608 module is designed to monitor battery voltage in real-time and automatically control a connected charger or load through its built-in relay. The module uses a three-digit 7-segment LED display to show voltage, and three push-buttons (SET, +, -) for menu navigation and configuration.
The voltage at which the charger turns OFF because the battery is full.
With these settings, the XH-M608 will protect the battery, and the micro-controller will automatically handle the cut-offs, saving power and preventing damage. Xh-m608 Manual
The for such a device is critical because the module is often sold without detailed printed instructions, or with a minimal, poorly translated leaflet.
Follow these steps to program your module for a standard (Start charging at 10.5V, Stop charging at 14.4V). Step 1: Set the Operating Mode (P3) Press and hold SET for 3 seconds until P1 flashes. Press + or - until the screen displays P3 . Press SET briefly to enter the P3 sub-menu. Use + or - to select CH (Charging Mode). Press SET to confirm. Step 2: Set the Lower Voltage Limit (P1) From the main menu, use + or - to navigate to P1 . Press SET briefly. The current voltage value will flash. Use + or - to adjust the value to 10.5V . Press SET to confirm. Step 3: Set the Upper Voltage Limit (P2) From the main menu, use + or - to navigate to P2 . Press SET briefly. The current voltage value will flash. Use + or - to adjust the value to 14.4V . Press SET to confirm. Step 4: Save and Exit
Elias wired his battery to the center terminals. The board hummed to life, its bright red digits showing . To Elias, this wasn't just a voltage readout; it was the heartbeat of his workshop. He followed the "sacred text" (the manual) to set the boundaries:
Features a programmable timing function useful for battery capacity testing and maintenance. The module uses a three-digit 7-segment LED display
DC 6-40V XH-M608 Battery Charge Discharge Module ... - AliExpress
*Sources: *
Use this mode to prevent over-discharging (deep discharge) when running appliances or loads from a battery.
The relay closes when the voltage rises to P2 and opens when it drops to P1 . P4: Voltage Calibration The for such a device is critical because
The Ultimate XH-M608 Manual: How to Configure and Wire Your Battery Charge Control Module
: The load stays ON only when voltage is between 11.0V and 13.0V. If voltage goes outside this range, the relay activates and disconnects the load.
Widen the gap between your upper and lower voltage limits to accommodate the natural voltage sag of your battery under load. The module does not turn on
Terminals for measuring the battery's real-time voltage.