Phison Mpall V5.13.0c

If the grid box turns yellow or shows an error immediately, your configuration file ( MP.ini ) contains an incorrect parameter or your burner file is mismatched. Click the button located at the bottom left.

2. Download Correct Firmware Binaries (Optional but Recommended)

Version is particularly stable for older Phison chips (PS2251-xx series, like PS2251-03, PS2251-07, PS2251-09).

To use this version for repairing a drive, users typically follow these steps:

Hard-codes an ISO file onto the controller chip so the USB drive registers in Windows as a physical CD-ROM/DVD-ROM drive (ideal for unbrickable bootable toolkits). Phison Mpall V5.13.0c

Avoid USB 3.0 or USB-C ports during the flashing process. Native USB 2.0 ports on the rear of a desktop motherboard offer the most stable voltage supply. Step 3: Step-by-Step Configuration Guide

Before starting, you must identify your drive's controller and memory type. Identify Hardware : Use a tool like ChipGenius Flash Drive Information Extractor to find your Controller Model (e.g., PS2251-07) and Download Firmware

: Scans the NAND flash memory, maps out dead sectors, and restores structural stability.

Using MPALL is a technical process that carries a risk of permanently "bricking" the hardware if the wrong firmware is applied. If the grid box turns yellow or shows

In MPParamEdit, select and click New Setting .

Error reporting and diagnostics

: It is compatible with a wide range of Phison USB controllers, including PS2251-07 , PS2251-67 , PS2251-03 , and newer models like PS2251-13/15 .

Phison MPALL (Mass Production Tool) is an official proprietary software suite used by manufacturers and technicians. The version is specifically optimized for a distinct generation of Phison microcontrollers (such as the PS2251 series). Native USB 2

: The actual operating code written to the flash memory.

1. Run MPParamEdit_F1.exe 2. IC Type = Auto (or match controller) 3. Partition Mode = 2 (Public only) 4. Format = Tick + Low Level Format 5. Save .ini 6. Open main MPALL tool, load .ini, scan, start 7. Wait 5-10 minutes 8. Re-plug USB → fixed

Watch the progress bar inside the active grid slot. The software will cycle through various statuses: Initial Read, Erasement, ISP Burning, and Format .

Download ChipGenius (portable tool). It scans USB controllers and reports the exact chip model (e.g., PS2251-03 , PS2251-07 ). MPall v5.13.0c works best with these series.