Manual: Xy-w58cdt9-av7
Brings up the main settings directory tree layout. It serves as the primary confirmation mechanism to validate chosen options.
General ledger (T-accounts) — key accounts
Confirm that your computer or video device is actively outputting a valid signal. Press the SOURCE key to force the board to re-scan physical ports.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. New Original LCD Driver Board XY-W58CDT9-AV7 xy-w58cdt9-av7 manual
If your project involves going beyond standard installation, keep these advanced tips in mind:
Increases the active option value or moves upward through selection lists.
| Parameter | Value (Typical for XY-W58CDT9-AV7) | |--------------------------|------------------------------------------------| | Supply voltage | DC 7V to 32V (or AC 7V to 30V depending) | | Power consumption | < 1W (idle), < 2W (relay active) | | Relay contact rating | 10A @ 250V AC / 10A @ 30V DC | | Time range | 0.1 seconds to 999 minutes (depends on base) | | Accuracy | ± 2% of set time (typical) | | Trigger input | Active high (3-30V) / Active low (0-0.8V) | | Operating temperature | -20°C to +60°C | | Dimensions (PCB) | Approx. 60mm x 45mm x 18mm | Brings up the main settings directory tree layout
MStar TSUMU58CDT9-1 (often marked as TSUMO58CDT9-1). Video Inputs: 1x HDMI, 1x VGA (D-Sub).
Confirm that your target LCD panel uses an LVDS interface and has a native resolution of 1920x1080 or lower.
The XY-W58CDT9-AV7 features a robust hardware set optimized for stability and visual clarity. : MStar TSUMU58CDT9-1. Input Ports : 1x HDMI and 1x VGA. Output Signal : 30-pin, 8-bit dual LVDS. Power Input : 12V DC (Operating range: 11.25V–13.25V). Audio : Integrated 2x3W amplifier with a 3.5mm jack output. Operating Temperature : 0°C to +40°C. Dimensions : 112mm x 53mm. Installation and Setup Guide Press the SOURCE key to force the board
The physical layout features designated terminals designed to safely carry signal outputs and power currents across the PCB footprint.
Press "Menu" or the dedicated "Source" button to switch between HDMI and VGA. Troubleshooting Tips XY-W58CDT9-AV7 Control Board for TFT LCD Displays
Locate the 3-pin jumper block labeled VCC or PANEL_VCC near the LVDS connector.
