Stc-600 Temperature Controller Manual Pdf (2027)
For more advanced configuration, such as changing compressor delay times or defrost cycles, you may need to enter the administrator menu. Press SET + Down Arrow together for 10 seconds. 3. Key Parameters Defined Set Temperature (S): The desired storage temperature.
Are you experiencing any specific on your display right now? Share public link
Do you need help calculating your values? Share public link
: Unlike many hobbyist controllers, it features a heavy-duty for compressors, fans, and defrosting. Dual Menu System Stc-600 Temperature Controller Manual Pdf
| Error Code | Meaning | Common Cause & Solution | | :--- | :--- | :--- | | | High Temperature Alarm | The measured temperature is above the high setpoint. Check if the sensor is faulty or the cooling system is failing. | | LLL | Low Temperature Alarm | The measured temperature is below the low setpoint, or the unit has iced up. Check for a faulty sensor or possible ice buildup. | | Flashing "HHH" | Sensor Failure | The controller cannot read the sensor signal. The internal temperature is too high, or the cabinet sensor is faulty. | | Flashing "LLL" | Sensor Failure or Icing | The internal temperature is too low, the unit has iced up, or the cabinet sensor is faulty. | | E1 (on some units) | Cabinet Sensor Failure | The primary temperature sensor inside the cabinet is not working. | | E2 (on some units) | Evaporator Sensor Failure | The sensor on the evaporator coil (used for defrost) has failed. |
Wire your compressor or cooling device in series with the cooling relay across terminals 5 and 6.
Understanding the electrical and environmental limits of the STC-600 ensures safe operation and prevents hardware damage. 220VAC ± 10%, 50/60Hz Temperature Measuring Range: -40°C to +70°C Temperature Controlling Range: -40°C to +50°C Resolution: 1°C Accuracy: ±1°C Relay Output Capacity: 8A / 220VAC (for compressor) Defrost Options: Natural defrost or electrical defrost Sensor Type: NTC sensor (2-meter cable included) Safe Delay Time: 0 to 9 minutes adjustable 📐 Wiring and Installation For more advanced configuration, such as changing compressor
The STC-600 temperature controller is a digital temperature control device designed to regulate temperature in various applications. It features a user-friendly interface, high accuracy, and reliability, making it a preferred choice among industries. The device is equipped with a range of features, including:
Always disconnect the main power supply before handling electrical connections. Wiring Terminal Layout
Solution: Check if the refrigeration system is running continuously without cycling off. Key Parameters Defined Set Temperature (S): The desired
Rhino Electronic Controller Support often carries STC-600 variants specifically for commercial beverage coolers. stc-600 instructions
Refer to the STC-600 temperature controller manual PDF for detailed configuration instructions.
: Increases parameter values or navigates up the menu.
Programming the STC-600 requires modifying parameters within its internal menu. Below is the official internal menu map. Parameter Code Function Description Setting Range Default Factory Value Temperature Set Value (Target Temperature) -40°C to +50°C F2 Temperature Hysteresis (Differential) 1°C to 10°C F3 Compressor Startup Delay Protection 0 to 9 minutes F4 Defrost Cycle Time (Interval) 0 to 99 hours F5 Defrost Duration Time 0 to 99 minutes 20 minutes F6 Defrost Termination Temperature 0°C to 50°C F7 Fan Operating Mode
[SV] Set value [PV] Current temperature +-----------------+ | STC-600 | | [PV] 25.5°C | | [SV] 22.0°C | | [Cooling LED] | | [Heating LED] | | [SET] [▼] [▲] | +-----------------+
