Open the battery cover and press the or [Registration] button.
Ensure the deadbolt aligns perfectly with the strike plate on the door frame. Card overwritten or unregistered
To prevent strangers from guessing your code by watching you or looking at fingerprint smudges, you can enter random numbers before or after your actual PIN code.
Open the battery cover on the inside unit and press the once. (The keypad outside will light up).
Press the to complete the registration. Daily Operation and Usage Unlocking from the Outside gateman v20 manual
: You can toggle this via a switch located under the battery cover. "A" stands for Automatic (locks immediately upon closing), and "M" stands for Manual.
Press [Reg] -> Contact each card on the reader one by one -> Press [Reg]. Volume Control
Press the button to complete registration. 3. Daily Operation Instructions 3.1 Unlocking from the Outside
To prevent strangers from guessing your code by watching your finger movements or looking at fingerprint smudges, use the fake PIN function: Touch the keypad to wake it up. Enter any random string of numbers. Enter your actual PIN code immediately after. Press to unlock. 🚨 Troubleshooting and Emergency Guide 1. The Lock is Completely Dead (No Power) Open the battery cover and press the or
The Gateman V20 is a popular, sleek, and reliable digital door lock known for its keyless convenience and robust security features. Whether you just installed a new unit or need to reprogram an existing one, this comprehensive manual provides everything you need to know. 🛠️ Essential Safety and Care Instructions
If the 4 AA batteries die (which typically last about a year), there is a hidden flap on the exterior. You can touch a 9V PP3 battery to the contact points to provide temporary power and operate the lock.
Drill a 32mm hole through the door for the connecting cable and mounting cylinder.
To program your lock, you must access the located inside the battery compartment on the interior unit. Keep the door open during programming to prevent accidentally locking yourself out. 1. Setting or Changing the Master PIN Code Open the battery cover on the inside unit. Press the [R] button once (you will hear a beep). Open the battery cover on the inside unit and press the once
Note: The Master PIN is used to register other users. Do not forget this code.
Locate the two metallic contact points at the bottom or front of the outside unit.
: The lock can be set to "Auto-Lock" (locks within 5 seconds of closing) or "Manual Mode" (requires a palm touch or button press to lock). Programming Guide Most programming is initiated via the Registration Button (often labeled as ) located inside the battery cover. Change PIN
Mark the center of the main 32mm hole for the connecting cable. Drill the 32mm hole cleanly through the door. Step 2: Install the Front Body