Hw 130 Motor Control Shield For Arduino Datasheet Free !!better!! -

The HW-130 doesn’t have its own official datasheet – it’s a shield based on the :

The HW-130 motor control shield is a compact, hobbyist-oriented add-on board designed to give Arduino users simple, reliable control over DC motors and small stepper motors. Though the HW-130 name describes a family of low-cost shields rather than a single manufacturer-standardized product, these shields share common design goals: make motor-driving circuits accessible to beginners, provide a straightforward Arduino-compatible interface, and include protective features that reduce the risk of damaging the controller or motors.

A 2-pin screw terminal dedicated to external motor power. Power Management and Jumpers hw 130 motor control shield for arduino datasheet free

This design frees up the majority of your Arduino's I/O pins for other tasks like sensors and displays.

The HW‑130 motor shield runs on the popular L293D dual‑bridge driver chip. Key specifications provided by hardware vendors include: The HW-130 doesn’t have its own official datasheet

Central pins on the 5-pin output terminals serve as the common ground connection for stepper motors. Servo Headers SERVO_1: Driven by Arduino digital pin 10. SERVO_2: Driven by Arduino digital pin 9. Internal Chip Pin Mapping

Digital pins 2 and 13, and all Analog pins (A0-A5), are typically left unused and can be used for sensors. 🔋 Power Management There are two main ways to power your setup: Power Management and Jumpers This design frees up

4 bi-directional DC motors with 8-bit speed selection (~0.5% resolution).

Independently control the speed and direction of two DC motors.