: High-sensitivity options including FID, TCD, ECD, FPD, and FTD (NPD). 2. Installation & Service Requirements
Igniter failure (FID), dirty collector, or disconnected signal cable.
Disconnect the main carrier gas supply line from the back of the GC unit to ensure there is zero physical pressure entering the system.
This comprehensive guide synthesizes critical service procedures, troubleshooting matrices, and hardware configurations to help laboratory technicians and service engineers keep the GC-2010 operating at peak performance. 1. Document Overview and Safety Standards
Turn off the flame, cool the detector to room temperature, and shut off air/hydrogen gases. shimadzu gc-2010 service manual
While a full manual is irreplaceable, here are a few common GC-2010 issues and their typical solutions:
Located on the right side and top right, housing the Advanced Pressure Controller (APC), detector blocks (FID, TCD, ECD, FPD), and the main CPU board. 2. Advanced Flow Controller (AFC) Calibration and Repair
: Capable of cooling from 450°C to 50°C in approximately 6 minutes. Injection Units
Inspect the injection port septum; change if showing signs of coring or needle wear. : High-sensitivity options including FID, TCD, ECD, FPD,
Insert a new, deactivated glass liner (with fresh glass wool if required for split injections).
The Flame Ionization Detector (FID) and Electron Capture Detector (ECD) utilize high polarization voltages. Always power down the instrument and disconnect the main power cord before removing chassis panels.
The is the essential technical document for maintaining and repairing the GC-2010 gas chromatograph. It provides authorized service personnel with detailed procedures for instrument configuration, troubleshooting, and parts replacement to ensure long-term analytical precision. Core Technical Specifications
GC-2010 Service Manual Overview | PDF | Power Supply | Humidity. 100%(1)100% found this document useful (1 vote) 1K views91 pages. GC-2010 Gas Chromatograph INSTRUCTION MANUAL Disconnect the main carrier gas supply line from
A thorough understanding of the service manual allows for proactive maintenance, preventing costly downtime. 1. System Overview and Specifications
Command the system to output a split flow of 50 mL/min. Measure the physical output. If the deviation exceeds ±1%, adjust the electronic correction factor in the maintenance software. 3. Oven Heating Element and Fan Assembly Service
Shut off the supply lines for carrier gas (helium/hydrogen), makeup gas (nitrogen), and detector gases (air/hydrogen for FID).