Skip to main content

⚠FRAUD ALERT: Scammers may impersonate Alltru through fake texts and phone calls with misleading links or phone numbers. Do not click links or share personal or account information. If you suspect you received a scam phone call, hang up and call us back.

Lambert Lx 24 Fi Manual English Page

The Lambert Lx 24 Fi is a highly efficient, wall-mounted combi boiler designed for residential heating and domestic hot water production. This guide provides a detailed breakdown of the technical specifications, installation requirements, operation instructions, and troubleshooting steps found in the official English manual. 1. Technical Specifications and Overview

The is a highly efficient, wall-mounted gas combi boiler. It utilizes a sealed combustion chamber (hermetic design) and forced draft ventilation to provide both domestic hot water (DHW) and central heating.

: Turn it to the snowflake icon to activate both radiators and hot water. Temperature Settings : Heating : Select a temperature between Hot Water : Select a temperature between

| Symptom | Possible cause | Remedy | |---------|----------------|--------| | Engine won’t start | No fuel, Fi LED red, spark plug wet | Refuel, check ECU code, dry/clean plug | | Hard starting / misfire | Dirty air filter, bad fuel, weak spark | Clean filter, replace fuel, check spark plug | | Engine runs rough | Fi system needs reset | Turn off ignition for 10 sec, restart | | Loss of power | Clogged injector, valve clearance off | Clean injector, adjust valves | | LED flashes 3x red | Low oil shutdown | Add oil, check oil level sensor | Lambert Lx 24 Fi Manual English

Indicates the burner is lit. The size of the flame icon scales with the modulation level.

The Lambert Lx 24 Fi has a built-in anti-frost safety mechanism. Keep the electrical supply turned on and the gas supply active during winter. If the internal water temperature drops below 5∘C5 raised to the composed with power C , the boiler automatically fires up to heat the water to 30∘C30 raised to the composed with power C to prevent frozen, burst pipes.

: Provides a hot water flow rate of 10.7 L/min at a temperature increase of 30∘C30 raised to the composed with power cap C Pressure Ratings : Heating Circuit: Maximum 3 bar. DHW Circuit: Maximum 8 bar. The Lambert Lx 24 Fi is a highly

If you encounter any issues with your Lambert Lx 24 Fi, refer to the troubleshooting section of the manual. This section provides a list of common problems and their solutions.

, the boiler will stop. Open the (water tap underneath) to increase pressure to Overheating: The boiler has reached too high a temperature. Routine Maintenance

The boiler can still run central heating but will not regulate hot water effectively until the DHW NTC sensor is swapped out. E10: Low Water Pressure Technical Specifications and Overview The is a highly

Understanding the technical boundaries of your appliance ensures safe and optimal operation.

While there are no academic papers specifically dedicated to the Lambert Lx 24 Fi

Tap water sensor failure. Hot water may fluctuate or stop heating. Low Water Pressure