Remington Rand — 1911a1 Markings [updated]

The left side of the slide contains the primary manufacturer markings. Remington Rand utilized three distinct roll stamp variations during wartime production. Type 1 (Early 1943) "REMINGTON RAND INC. / SYRACUSE, N.Y. U.S.A." Appearance: The text is set in a script-style, serif font. Serial Range: Roughly 916,405 to 955,000. Type 2 (Mid 1943) Text: "REMINGTON RAND INC. / SYRACUSE, N.Y. U.S.A."

Because Remington Rand did not make all their own parts, you will find cryptic letters and symbols inside the slide, on the barrel, and on small components. These are not defects; they are .

The logo was slightly compressed and moved toward the muzzle to clear the slide notch. "NEW YORK" was abbreviated to "N.Y.". Type 3 (1944–1945):

— The earliest variation, seen on pistols with serial numbers ranging from approximately 916,405 to about 935,000. The left side of the slide reads: REMINGTON RAND, INC. / SYRACUSE, NEW YORK . Collectors often refer to this as the "New York slide" because "New York" is spelled out fully. This variant was used during Remington Rand's initial production startup.

Stamped ahead of the slide stop pin hole. remington rand 1911a1 markings

This rare marking appears on roughly the first 10,000 pistols. It erroneously credited the tool manufacturer, Pratt & Whitney, instead of the actual production location. Serial Range: Approximately 916,405 to 926,404. Type 2 (Mid 1943) Text: REMINGTON RAND INC. WEST HARTFORD, CONN. U.S.A. Use code with caution.

Perhaps the most commonly overlooked markings on Remington Rand pistols are the various letters and numbers stamped around the trigger guard. These marks represent assembly workers' inspection stamps—part of an internal quality control system implemented during production.

The most visible marking is the manufacturer's name on the slide. Remington Rand significantly altered their rollmark design three times. Identifying which type you have is the first step to dating the pistol.

Remington Rand slide markings changed over time, usually classified into "Types." The left side of the slide contains the

You will often find small, single-digit numbers or letters stamped on the trigger guard loops (both left and right sides). These were internal Remington Rand factory inspection marks used to track quality control during individual shifts. Arsenal Rebuild Markings (Post-WWII)

Wartime quality control required individual component verification proofs.

Remington Rand M1911A1 was the most-produced variant of the iconic service pistol during World War II, with over 877,000 units manufactured in Syracuse, NY, between 1942 and 1945

Here are some specific markings that may be found on a Remington Rand 1911A1: / SYRACUSE, N

The address was shortened to "REMINGTON RAND INC. / SYRACUSE, N.Y." in smaller lettering. This is the most common variation. 2. Frame & Inspector Markings

The markings covered in this guide—from the three slide types to the FJA inspector's stamp, from the crossed cannons to the trigger guard assembly codes—form the foundation of any serious collection of World War II firearms. Whether you are examining a pistol for purchase, researching a family heirloom, or simply appreciating the history held in these steel frames, understanding the marks left by Remington Rand's wartime production gives you the ability to unlock the past, one stamp at a time.

The lettering is formatted in two lines, left-justified. It features a larger font size than later types. Text: REMINGTON RAND INC. SYRACUSE, N.Y. U.S.A. Type 2 (March 1943 to May 1943) Serial Range: ~1,015,000 to ~1,042,000