If the server was previously deployed in a production environment, the default password was likely changed for security compliance. You will need to recover the password from the previous administrator or reset the iRMC to factory settings (see below).
🔐 Immediately change the default password after first login. The default admin / admin is widely known and a serious security risk if the iRMC is exposed to a network.
Run the following command to set a new password for the admin user (User ID 2): ipmitool user 'YourNewPassword123!' Use code with caution. Copied to clipboard On Windows Download the Fujitsu IPMIVIEW tool
As detailed in the setup section above, physical access allows you to bypass network authentication. Boot the server into the , navigate to Server Management -> iRMC User Configuration , and overwrite the current password with a new one. Option B: Local OS IPMI Reset
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. fujitsu irmc default password
Older systems often shipped with the static default password admin .
Never expose the iRMC port directly to the public internet or standard corporate LAN. Place it on a dedicated, non-routable Management VLAN accessible only via secure VPN or administrative jump boxes.
In 2023, a scanning project of public IPv4 addresses found over 10,000 Fujitsu servers with their iRMC exposed directly to the internet. Of those, a shocking percentage still used admin / admin .
Fujitsu iRMC Default Password Guide: Accessing and Securing Your Server Management If the server was previously deployed in a
Older PRIMERGY motherboards often have a "password clear" or "reset" jumper near the SATA ports that can clear BIOS and management passwords. Refer to your specific model's Maintenance Manual for the exact location. Fujitsu Global IPMITool command for a different operating system, such as VMware ESXi AI responses may include mistakes. Learn more
A: Yes, the serial console uses the same local user database. Default = admin / admin .
Check the pull-out plastic System ID Card located on the front or rear of the chassis. If the chassis configuration lacks space for a pull-out tab, look for a dedicated printed label adhered directly to the server's top cover .
Fujitsu Integrated Remote Management Controller (iRMC) is an onboard management processor used to configure, monitor, and maintain Fujitsu PRIMERGY servers. Like many enterprise-grade lights-out management solutions, iRMC comes with a standard default credential set out of the box. The default admin / admin is widely known
For very old servers (e.g., PRIMERGY TX300 S5, RX200 S5), the default pair was also admin / admin . There were no documented variations.
Locate the admin user, choose , enter your new credentials, then save and exit (F10). Method 3: Via ServerView Agents / Local OS Command Line
Disclaimer: This article is for informational purposes. Always refer to the official Fujitsu ServerView documentation for your specific hardware model before performing hardware resets or BIOS modifications.
To ensure the security of your iRMC deployment, follow these best practices: